No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD to Monitor a BGP Tunnel

Configuring Dynamic BFD to Monitor a BGP Tunnel

On an IP/MPLS network transmitting VPN services, PEs establish a multi-segment MPLS tunnel between each other. Therefore VPN services are sent to multiple PEs. In this case, VPN service provision on PEs becomes complex, and the VPN service scalability decreases. As PEs establish BGP peer relationships, a routing policy can be used to assign MPLS labels for BGP routes so that an E2E BGP tunnel can be established. The BGP tunnel consists of a primary BGP LSP and a backup BGP LSP. VPN services can travel along the E2E BGP tunnel, which simplifies service provision and improves VPN service scalability.

To rapidly detect faults in an E2E BGP tunnel, BFD for BGP tunnel is used. BFD for BGP tunnel establishes a dynamic BFD session, also called a BGP BFD session, which is bound to both the primary and backup BGP LSPs. If both BGP LSPs fail, the BGP BFD session detects the faults and triggers VPN FRR switching.

Pre-configuration Tasks

Before configuring dynamic BFD to monitor a BGP tunnel, configure basic MPLS functions.

Configuration Procedure

Configure dynamic BFD to monitor a BGP tunnel according to the following sequence.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 23751

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next