No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LSR ID

Configuring LSR ID


An LSR ID identifies an LSR on a network. An LSR does not have the default LSR ID, and you must configure an LSR ID for it. To enhance network reliability, you are advised to use the IP address of a loopback interface on the LSR as the LSR ID.

Perform the following steps on each node in an MPLS domain.


  1. Run system-view

    The system view is displayed.

  2. Run mpls lsr-id lsr-id

    The LSR ID of the local node is configured.

    By default, no LSR ID is set.

Follow-up Procedure

Before changing the configured LSP ID, run the undo mpls command in the system view.

Running the undo mpls command to delete all MPLS configurations will interrupt MPLS services, so plan the LSR ID of each LSP uniformly to prevent LSR ID change.

Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 25835

Downloads: 28

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next