No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RSVP-TE Refresh Mechanism

Configuring RSVP-TE Refresh Mechanism

Context

Enabling Srefresh in the mpls view on two nodes that are the neighbors of each other can reduce the cost and improve the performance of a network. In the MPLS view, Srefresh can be enabled on the entire device. After Srefresh is enabled, the retransmission of Srefresh messages is automatically enabled on the interface or the device.

NOTE:

The Srefresh mechanism in MPLS view is applied to the TE FRR networking. Srefresh is enabled globally on the Point of Local Repair (PLR) and Merge Point (MP) over an FRR bypass tunnel. This allows efficient use of network resources and improves Srefresh reliability.

Assume that a node initializes the retransmission interval as Rf seconds. If receiving no ACK message within Rf seconds, the node retransmits the RSVP message after (1 + Delta) x Rf seconds. The value of Delta depends on the link rate. The node retransmits the message until it receives an ACK message or the times of retransmission reach the threshold (that is, retransmission increment value).

Perform the following configurations on each node of the MPLS TE tunnel.

Procedure

  • Perform the following steps in the MPLS view.
    1. Run system-view

      The system view is displayed.

    2. Run mpls

      The MPLS view is displayed.

    3. Run mpls rsvp-te srefresh

      Srefresh is enabled.

      By default, Srefresh is disabled globally.

  • Perform the following steps in the interface view.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run mpls rsvp-te srefresh

      Srefresh is enabled.

      By default, Srefresh is disabled on all interfaces.

    5. (Optional) Run mpls rsvp-te timer retransmission { increment-value increment | retransmit-value interval } *

      The retransmission parameters are set.

      By default, increment is set to 1, and interval is set to 5000 milliseconds.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 26264

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next