No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the LDP Running Status

Monitoring the LDP Running Status

Context

In routine maintenance, you can run the following commands in any view to view the LDP running status.

Procedure

  • Run the display mpls ldp error packet { tcp | udp | l2vpn } [ number ] command to check statistics on LDP error messages.
  • Run the display mpls ldp error packet state command to check the record status of LDP-related error messages.
  • Run the display mpls ldp event adjacency-down [ interface interface-type interface-number | remote ] [ peer peer-id ] [ verbose ] command to check information about LDP adjacencies in Down state.
  • Run the display mpls ldp event session-down command to check information about LDP sessions in Down state.
  • Run the display mpls last-info lsp-down [ protocol ldp ] [ verbose ] command to check information about LDP LSPs in Down state.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20300

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next