No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of a Static MPLS TE Tunnel

Verifying the Configuration of a Static MPLS TE Tunnel


The configurations of the static MPLS TE tunnel are complete.


  • Run the display mpls static-cr-lsp [ lsp-name ] [ { include | exclude } ip-address mask-length ] [ verbose ] command to check information about the static CR-LSP.
  • Run the display mpls te tunnel [ destination ip-address ] [ lsp-id ingress-lsr-id session-id local-lsp-id ] [ lsr-role { all | egress | ingress | remote | transit } ] [ name tunnel-name ] [ { incoming-interface | interface | outgoing-interface } interface-type interface-number ] [ verbose ] command to check tunnel information.
  • Run the display mpls te tunnel statistics or display mpls lsp statistics command to check the tunnel statistics.
  • Run the display mpls te tunnel-interface [ tunnel interface-number ] command to check information about the tunnel interface on the ingress node.
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 24071

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next