No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the RSVP Signaling Delay-Trigger Function

Configuring the RSVP Signaling Delay-Trigger Function

Context

In the case that a fault occurs on an MPLS network, a great number of RSVP CR-LSPs need to be reestablished. This causes consumption of a large number of system resources. By configuring the delay for triggering the RSVP signaling, you can reduce the consumption of system resources when establishing an RSVP CR-LSP.

Perform the following configurations on each node on which multiple CR-LSPs need to be reestablished.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls te signaling-delay-trigger enable

    The RSVP signaling delay-trigger function is enabled.

    By default, the RSVP signaling delay-trigger function is not enabled.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 26522

Downloads: 32

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next