No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Auto Bypass Tunnel Re-Optimization

(Optional) Configuring Auto Bypass Tunnel Re-Optimization

Context

Network changes often cause the changes in optimal paths. Auto Bypass tunnel re-optimization allows paths to be recalculated at certain intervals for an auto bypass tunnel. If an optimal path to the same destination is found due to some reasons, such as the changes in the cost, a new auto bypass tunnel will be set up over this optimal path. In this manner, network resources are optimized.

Perform the following configurations on the PLR.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls te auto-frr reoptimization [ frequency interval ]

    Auto bypass tunnel re-optimization is enabled.

    By default, auto bypass tunnel re-optimization is disabled. If re-optimization is enabled, the default interval at which auto bypass tunnel re-optimization is performed is 3600 seconds.

  4. (Optional) Immediately re-optimize the TE tunnels.
    1. Run return

      Return to the user view.

    2. Run mpls te reoptimization

      Manual re-optimization is enabled.

      After you configure the automatic re-optimization in the tunnel interface view, you can return to the user view and run the mpls te reoptimization command to immediately re-optimize the TE tunnels. After you perform the manual re-optimization, the timer of the automatic re-optimization is reset and counts again.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 24316

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next