No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LDP over TE

Configuring LDP over TE

Context

MPLS TE supports strong traffic engineering capabilities and provides various QoS guarantees. Due to live network limitations, such as application types and costs, deploying MPLS TE on the entire network is difficult. Therefore, LDP over TE can be used to deploy MPLS TE on a core area and LDP on non-core areas.

Pre-configuration Tasks

Before configuring LDP over TE, complete the following tasks:

  • Configure IGP to implement the reachability between LSRs.

  • Configure basic MPLS functions of all nodes and interfaces.

  • Enable MPLS LDP on the interface in the non-TE domain.

  • Configure RSVP-TE Tunnel on the TE node.

Configuration Procedure

Configure LDP over TE according to the following sequence.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 21674

Downloads: 22

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next