No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Adjusting the Path of a CR-LSP

Verifying the Configuration of Adjusting the Path of a CR-LSP

Prerequisites

The configurations of adjusting the path of a CR-LSP are complete.

Procedure

  • Run the display mpls te tunnel verbose command to check information about the MPLS TE tunnel.
  • Run the display mpls te srlg { srlg-number | all } command to check the SRLG configuration and interfaces in the SRLG.
  • Run the display mpls te link-administration srlg-information [ interface interface-type interface-number ] command to check the SRLG that interfaces belong to.
  • Run the display mpls te tunnel c-hop [ tunnel-name ] [ lsp-id ingress-lsr-id session-id lsp-id ] command to check path computation results of tunnels.
  • Run the display default-parameter mpls te cspf command to check default CSPF settings.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20460

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next