No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an LDP Transport Address

(Optional) Configuring an LDP Transport Address

Context

LDP sessions are established based on TCP connections. Before two LSRs establish an LDP session, they need to check the LDP transport address of each other, and then establish a TCP connection.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface on which the LDP session is to be set up is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run mpls ldp transport-address { interface-type interface-number | interface }

    An LDP transport address is specified.

    The default transport address for a node on a public network is the LSR ID of the node, and the default transport address for a node on a private network is the primary IP address of an interface on the node.

    If LDP sessions are to be established over multiple links connecting two LSRs, LDP-enabled interfaces on either LSR must use the default transport address or the same transport address. If multiple transport addresses are configured on an LSR, only one transport address can be used to establish only one LDP session.

    Changing an LDP transport address interrupts an LDP session. Exercise caution when running this command.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 19929

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next