No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring LDP to Automatically Trigger the Request in DoD Mode

(Optional) Configuring LDP to Automatically Trigger the Request in DoD Mode

Context

On a large-scale network, the label advertisement mode is set to downstream on demand (DoD) to reduce the workload of edge devices. Because edge devices cannot learn the accurate route to each other, an LDP LSP cannot be set up even if LDP extensions for inter-area LSPs are configured. You can configure LDP to automatically trigger the request in DoD mode to request the Label Mapping message from a specified downstream LSR or all LSRs for LDP LSP establishment.

Before configuring LDP to automatically trigger the request in DoD mode, perform the following operations:

Procedure

  • Configure automatic triggering of requests for Label Mapping messages in DoD mode from all downstream remote LDP peers.
    1. Run system-view

      The system view is displayed.

    2. Run mpls ldp

      The MPLS LDP view is displayed.

    3. Run remote-peer auto-dod-request

      LDP is configured to automatically trigger requests for Label Mapping messages in DoD mode from all downstream remote LDP peers.

      By default, the device does not automatically trigger requests for Label Mapping messages in DoD mode from all downstream remote LDP peers.

  • Configure automatic triggering of a request for a Label Mapping message in DoD mode from a downstream remote LDP peer with a specified LSR ID.
    1. Run system-view

      The system view is displayed.

    2. Run mpls ldp remote-peer remote-peer-name

      A remote MPLS LDP peer is created and the remote MPLS LDP peer view is displayed.

    3. Run remote-ip auto-dod-request [ block ]

      LDP is configured to automatically trigger a request for a Label Mapping message in DoD mode from a downstream remote LDP peer with a specified LSR ID.

      By default, the configuration of the remote-peer auto-dod-request command is inherited.

      If the remote-peer auto-dod-request command is enabled in the system view, you can specify block to disable automatic triggering of a request for a Label Mapping message in DoD mode from a downstream remote LDP peer of a specified LSR ID.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20028

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next