No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling TE FRR

Enabling TE FRR

Context

TE FRR must be enabled for a primary tunnel before a bypass tunnel is established.

Perform the following configurations on the ingress node of an MPLS TE tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The interface view of a primary tunnel is displayed.

  3. Run mpls te fast-reroute [ bandwidth ]

    TE FRR is enabled.

    NOTE:

    Only the primary tunnel in a tunnel protection group can be configured together with TE FRR on the ingress node. Neither the protection tunnel nor the tunnel protection group itself can be used together with TE FRR. If the tunnel protection group and TE FRR are used, neither of them takes effect.

    For example, Tunnel1 and Tunnel2 are tunnel interfaces on MPLS TE tunnels and the tunnel named Tunnel2 has a tunnel ID of 200. The mpls te protection tunnel 200 and mpls te fast-reroute commands cannot be configured simultaneously on Tunnel1. That is, the tunnel protection group and TE FRR cannot be used together on Tunnel1. A configuration failure will occur if the mpls te protection tunnel 200 command is run on Tunnel1 and the mpls te fast-reroute command is run on Tunnel2.

  4. Run mpls te commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20283

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next