No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Hello Sessions Between RSVP GR Nodes

(Optional) Configuring Hello Sessions Between RSVP GR Nodes

Context

If TE FRR is deployed, a Hello session is required between a PLR and an MP.

Perform the following configurations on the PLR and MP of the bypass CR-LSP.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls rsvp-te hello nodeid-session ip-address

    A Hello session is set up between a restarting node and a neighbor node.

    ip-address is the LSR ID of the RSVP neighbor.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20479

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next