No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Attributes for a PW Template

Setting Attributes for a PW Template

Context

In load balancing, packet mis-sequencing may occur. The device can reassemble the packets using the control word function. To detect a PW based on a control word channel, you must enable the control word function by using a PW template before configuring dynamic BFD for PWs. Perform the following operations on the two PEs of the PW.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run pw-template pw-template-name

    The PW template view is displayed.

  3. Run control-word

    The control word function is enabled.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 34017

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next