No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the VLL Traffic Statistics Collection Function

Enabling the VLL Traffic Statistics Collection Function

Context

To collect statistics on VLL traffic, use one of the following methods:
  • Enable traffic statistics collection globally to collect traffic statistics on various AC interfaces.
  • Enable traffic statistics collection on the VLANIF interfaces bound to a specified VLL.

Procedure

  • Enable traffic statistics collection globally to collect traffic statistics on various AC interfaces.

    This method applies to only the VLLs created after traffic statistics collection is enabled. Therefore, to use this method, enable VLL traffic statistics collection on the device before you create the VLL. This method cannot collect traffic statistics on the inbound and outbound interfaces connected to the local VLL.

    1. Run the system-view command to enter the system view.
    2. Run the mpls l2vpn traffic-statistics enable command to enable VLL traffic statistics.
  • Enable traffic statistics collection on the VLANIF interfaces bound to a specified VLL.

    1. Run the system-view command to enter the system view.
    2. Run the interface vlanif vlan-id command to enter the VLANIF interface view bound to the VLL.
    3. Run the statistic enable { both | inbound | outbound } command to enable traffic statistics collection on the VLANIF interface bound to a specified VLL.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 38300

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next