No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Reflection for BGP VPNv6 Routes

Configuring Route Reflection for BGP VPNv6 Routes

Pre-configuration Tasks

Before configuring the route reflection for BGP VPNv6 routes, complete the following tasks:

  • Enable IPv6 globally on the PE, and enable IPv6 on the interfaces that need be configured with IPv6.

  • Configure the routing protocol for the MPLS backbone network to implement IP connectivity between devices in the backbone network.

  • Establish tunnels (LSPs or MPLS TE tunnels) between the RR and all PEs serving as the clients.

Configuration Procedure

All the following configuration tasks are mandatory.

Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39020

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next