No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Forwarding Isolation Between AC Interfaces

(Optional) Configuring Forwarding Isolation Between AC Interfaces

Context

If multiple users are bound to the same VSI, you can use the isolate spoken command to enable forwarding isolation between AC interfaces. After this command is run, the VSI attribute of all AC interfaces in the VSI is spoke, preventing the users from communicating with each other.

Before configuring forwarding isolation between AC interfaces, the VPLS signaling configuration must have been completed.
  • For Martini VPLS, the pwsignal ldp and vsi-id vsi-id commands have been run.

  • For Kompella VPLS, the pwsignal bgp and route-distinguisher route-distinguisher commands have been run.

  • For BGP AD VPLS, the bgp-ad and vpls-id vpls-id commands have been run.

NOTE:

Only the X series cards support this function.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vsi vsi-name

    The VSI view is displayed.

  3. Run isolate spoken

    Forwarding isolation between AC interfaces in the VSI is enabled.

    By default, forwarding isolation between AC interfaces in a VSI is disabled.

  4. Run quit

    Return to the system view.

  5. (Optional) If one AC interface wants to communicate with other AC interfaces in the same VSI, set the VSI attribute of this AC interface to hub.
    1. Run interface interface-type interface-number

      The AC interface view is displayed.

    2. Run hub-mode enable

      The VSI attribute of the AC interface is set to hub.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 32307

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next