No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the VLAN Range to Which an AC Sub-interface Sends L2VPN Loop Detection Packets

Configuring the VLAN Range to Which an AC Sub-interface Sends L2VPN Loop Detection Packets

Context

After L2VPN loop detection is enabled on an interface, the Dot1q termination sub-interface and QinQ termination sub-interface do not send L2VPN loop detection packets by default. You need to configure the VLAN range to which the Dot1q termination sub-interface and QinQ termination sub-interface send L2VPN loop detection packets. After the VLAN range is configured, the sub-interfaces send L2VPN loop detection packets to the specified VLANs.

Perform the following operations on the PE.

NOTE:

VLAN termination sub-interfaces cannot be created on a VCMP client. You can run the vcmp role command to configure the role for a switch in a VCMP domain.

L2VPN loop detection takes effect on a sub-interface. If any VLAN in the specified VLAN range that receives L2VPN loop detection packets has a loop, this sub-interface will be blocked.

Procedure

  • Configure the VLAN range to which a Dot1q termination sub-interface sends L2VPN loop detection packets.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number.subinterface-number

      The Dot1q termination sub-interface view is displayed.

    3. Run loop-detect detection vid low-vid [ to high-vid ]

      The VLAN range to which the Dot1q termination sub-interface sends L2VPN loop detection packets is configured.

      By default, the Dot1q termination sub-interface does not send L2VPN loop detection packets.

  • Configure the VLAN range to which a QinQ termination sub-interface sends L2VPN loop detection packets.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number.subinterface-number

      The QinQ termination sub-interface view is displayed.

    3. Run loop-detect detection pe-vid pe-vid ce-vid low-vid [ to high-vid ]

      The VLAN range to which the QinQ termination sub-interface sends L2VPN loop detection packets is configured.

      By default, the QinQ termination sub-interface does not send L2VPN loop detection packets.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 33720

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next