No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Manually Switching PWs in a PW Protection Group

(Optional) Manually Switching PWs in a PW Protection Group


If you want to maintain the device where the active PW is configured in a VPLS PW redundancy scenario, you can switch services from the active PW to the standby PW and switches services back after the device stabilizes.

Do as follows on the UPE devices:


  1. Run system-view

    The system view is displayed.

  2. Run vsi vsi-name static

    The view of the created VSI is displayed.

  3. Run pwsignal ldp

    The VSI-LDP view is displayed.

  4. Run protect-group group-name

    A PW protection group is created, and the PW protection group view is displayed.

  5. Run protect-switch manual

    An active/standby PW switchover is performed in the current PW protection group.

  6. Run protect-switch clear

    An active/standby PW switchback is performed in the current PW protection group.

Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39736

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next