No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the mVSI

Configuring the mVSI


To forward the mVRRP packets on the NPEs through the mVSI on the UPE, do as follows.


  1. Run system-view

    The system view is displayed.

  2. Run vsi vsi-name static

    A VSI is created and the static member discovery mechanism is configured.

  3. Run pwsignal ldp

    LDP is configured as the signaling protocol of the PW and the VIS-LDP view is displayed.

  4. Run vsi-id vsi-id

    The ID of the VSI is set.

  5. Run peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ] upe

    The VSI peer relationship is configured between the UPE and the SPE. The MPLS LSR ID of the SPE is configured as the peer address.

  6. Run quit

    Return to the VSI view.

  7. Run admin-vsi

    The VSI is configured as the mVSI.

Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39744

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next