No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Client PEs to Establish MP IBGP Connections with the RR

Configuring the Client PEs to Establish MP IBGP Connections with the RR

Context

Perform the following steps on all Client PEs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number as-number

    The RR is specified as the BGP peer.

  4. Run peer ipv4-address connect-interface interface-type interface-number

    The interface is specified as an interface to establish the TCP connection.

  5. Run ipv4-family vpnv4

    The BGP VPNv4 address family view is displayed.

  6. Run peer ipv4-address enable

    The capability of exchanging VPNv4 routes between the PE and RR is enabled.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 33793

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next