No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Martini VPLS

Configuring Martini VPLS

Pre-configuration Task

Before configuring Martini VPLS, complete the following tasks:
  • Configure LSR IDs and enabling MPLS on PEs and Ps.
  • Enable MPLS L2VPN on PEs.
  • Establish tunnels between PEs for data transmission.
  • Set up an LDP session if PEs are indirectly connected.

Configuration Procedure

To configure Martini VPLS, perform the following configurations on PEs at both ends of a PW.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39384

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next