No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BGP AD VPLS

Configuring BGP AD VPLS

Pre-configuration Task

BGP AD VPLS uses BGP packets to implement VSI discovery and uses the LDP FEC 129 signaling to establish PWs to implement VPLS PW automatic establishment.

Before configuring BGP AD VPLS, complete the following tasks:
  • Configure LSR IDs and enabling MPLS on PEs and Ps.
  • Enable MPLS L2VPN on PEs.
  • Establish tunnels between PEs for data transmission.

Configuration Procedure

To configure BGP AD VPLS, perform the following configurations on PEs at both ends of a PW.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 38301

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next