No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring L2VPN Loop Detection on the AC Side of a VPLS-capable Device

Configuring L2VPN Loop Detection on the AC Side of a VPLS-capable Device

Pre-configuration Tasks

After you configure L2VPN loop detection on the AC side of a VPLS-capable device, the device can timely detect and eliminate L2VPN network loops, preventing broadcast storms.

Before configuring L2VPN loop detection on the AC side of a VPLS-capable device, complete at least one of the following tasks:

Configuration Procedure

To configure L2VPN loop detection on the AC side of a VPLS-capable device, perform the following operations on the PE:

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 33181

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next