No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of VPN Tunnels

Monitoring the Running Status of VPN Tunnels


In routine maintenance, run the following commands in any view to view the tunnel status.


  • Run the display interface tunnel interface-number command to check information about a specified tunnel interface.
  • Run the display tunnel-info tunnel-id tunnel-id command to check detailed information about a specified tunnel.
  • Run the display tunnel-info all command to check information about all tunnels.
  • Run the display tunnel-policy [ tunnel-policy-name ] command to check the configuration of a tunnel policy.
  • Run the display ip vpn-instance verbose [ vpn-instance-name ] command to check information about the tunnel policy applied to a VPN instance.
  • Run the display ipv6 routing-table vpn-instance [ ip-address ] verbose command to view the tunnel to which VPN routes are iterated.
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39717

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next