No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Hub and Spoke

Configuring Hub and Spoke

In Hub and Spoke networking, a central site is deployed and all the other sites communicate through the central site. The central site controls communication between sites.

Pre-configuration Tasks

Before configuring Hub and Spoke, complete the following tasks:

  • Enable IPv6 on the devices.

  • Configure IGP on PEs and Ps in the MPLS backbone network.

  • Configure basic MPLS capability and MPLS LDP (or RSVP-TE) on PEs and Ps in the MPLS backbone network.

  • Configure the IP addresses, through which the CEs access the PEs, on the CEs.

Configuration Procedure

All the following tasks are mandatory. Perform these tasks in this sequence to complete the Hub and Spoke configuration.

Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 32532

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next