No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why the VSI Cannot Be Up When the Switch Connects to a Cisco Device Over the VPLS Network?

Why the VSI Cannot Be Up When the Switch Connects to a Cisco Device Over the VPLS Network?

On a Cisco device, a Layer 3 interface or main interface that is bound to a VSI uses the Ethernet encapsulation mode, and a sub-interface that is bound to a VSI uses the VLAN encapsulation mode by default. On a switch, a Layer 3 interface, main interface, or sub-interface that is bound to a VSI uses the VLAN encapsulation mode by default. If the encapsulation modes on the switch and Cisco device are different, the VSI cannot be Up.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 33064

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next