No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Inter-AS VPN Option B Configuration

Verifying the Inter-AS VPN Option B Configuration

Prerequisites

The configurations of the inter-AS VPN Option B function are complete.

Procedure

  • Run the display bgp vpnv6 all peer command on the PE or ASBR. If the status of the IBGP peer between the PE and ASBR in the same AS is "Established", and the status of the EBGP peer between ASBRs in the different AS is "Established", the configuration is successful.
  • Run the display bgp vpnv6 all routing-table command on the ASBR. If the VPN IPv6 routes are displayed, the configuration is successful.
  • Run the display ipv6 routing-table vpn-instance vpn-instance-name command on the PE. If the VPN routes are displayed, the configuration is successful.
  • Run the display mpls lsp command on the ASBR. If information about the LSP and label is displayed, it means that the configuration succeeds. If the ASBR is enabled with the next-hop-based label allocation, only one label is allocated for the VPN routes with the same next hop and outgoing label.
  • Run the display ip extcommunity-filter command on an ASBR to check the configured extended community filters.
  • Run the display ip rd-filter command on an ASBR to check the configured RD filters.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 32512

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next