No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the RR to Establish MP-IBGP Connections with All Client PEs

Configuring the RR to Establish MP-IBGP Connections with All Client PEs

Context

You can configure an RR to establish MP-IBGP peer relationships with all its client PEs. In this manner, the RR reflects VPNv6 routes for all these PEs. Configure the RR in either of the following ways:

Procedure

  • Configuring the RR to Establish MP-IBGP Connections with the Peer Group

    Add all the client PEs to the peer group and establish MP IBGP connection between the RR and the peer group.

    1. Run system-view

      The system view is displayed.

    2. Run bgp { as-number-plain | as-number-dot }

      The BGP view is displayed.

    3. Run group group-name [ internal ]

      An IBGP peer group is created.

    4. Run peer group-name connect-interface interface-type interface-number

      The interface is specified as an interface to establish the TCP connection.

    5. Run ipv6-family vpnv6

      The BGP VPNv6 address family view is displayed.

    6. Run peer group-name enable

      The capability of exchanging IPv6 VPN routes between the RR and the peer group is enabled.

    7. Run peer ipv4-address group group-name

      The peer is added to the peer group.

  • Configuring the RR to establish an MP-IBGP connection with each client PE

    Perform Step 1 to Step 6 repeatedly on the RR to establish an MP IBGP connection between the RR and each client PE.

    1. Run system-view

      The system view is displayed.

    2. Run bgp { as-number-plain | as-number-dot }

      The BGP view is displayed.

    3. Run peer ipv4-address as-number as-number

      The client PE is specified as the BGP peer.

    4. Run peer ipv4-address connect-interface interface-type interface-number

      The interface is specified as an interface to establish the TCP connection.

    5. Run ipv6-family vpnv6

      The BGP VPNv6 address family view is displayed.

    6. Run peer ipv4-address enable

      The capability of exchanging IPv6 VPN routes between the RR and the client PE is enabled.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 33664

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next