No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Establishing MP-IBGP Peer Relationships Between PEs

Establishing MP-IBGP Peer Relationships Between PEs


If VPN sites in a basic BGP/MPLS IPv6 VPN need to communicate, PEs must use MP-IBGP to advertise VPNv6 routes with the route distinguisher (RD) information to each other. Since all the PEs reside in the same AS, MP-IBGP peer relationships can be set up between them. In the current implementation, IPv4 BGP peer relationships are set up between PEs.

Perform the following steps on the PEs:


  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number as-number

    The peer PE is configured as a BGP peer.

  4. Run peer ipv4-address connect-interface loopback interface-number

    An interface is used to set up a TCP connection with the BGP peer.


    A PE must use a loopback interface address with a 32-bit mask to set up an MP-IBGP peer relationship with the peer PE so that VPN routes can be iterated to tunnels. The route to the local loopback interface is advertised to the peer PE using an IGP on the MPLS backbone network.

  5. Run ipv6-family vpnv6

    The BGP VPNv6 address family view is displayed.

  6. Run peer ipv4-address enable

    The ability to exchange VPN IPv6 routes with the BGP peer is enabled.

Related Tasks

When a large number of PEs on the backbone network need to establish MP-IBGP peer relationships to exchange VPN routes, configure a route reflector (RR) to reduce the number of MP-IBGP connections between PEs. The PEs only need to establish MP-IBGP peer relationships with the RR. For detailed configuration, see Configuring Route Reflection for BGP VPNv6 Routes.

Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39288

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next