No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Inter-AS VLL

Configuring Inter-AS VLL

Context

The configuration of an inter-AS VLL varies with the VLL implementation mode.
  • The CCC mode uses a single label. Therefore, the inter-AS VLL can be set up when static LSPs are set up between ASBRs.

  • The Martini, SVC, and Kompella modes can implement inter-AS VLL Option A (VRF-to-VRF).

To configure inter-AS Option A, you must specify an interface (a sub-interface, a physical interface, or a bundled logical interface) for each inter-AS VC on ASBRs.

Procedure

To implement inter-AS Option A, complete basic VLL configurations in each AS and configure the ASBR-PE devices to be recognized as the CE devices by each other.

NOTE:

You do not need to perform any additional configuration for inter-AS implementation on ASBRs and do not need to configure IP addresses for the directly connected interfaces between ASBRs.

Verifying the Configuration

  • Run the display vll ccc [ ccc-name | type { local | remote } ] command to check information about a CCC VLL.
  • Run the display l2vpn ccc-interface vc-type ccc [ down | up ] command to check information about interfaces used by the CCC VLL.
  • Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command to check PW information about the local end of a Martini VLL.

  • Run the display mpls l2vc remote-info [ vc-id ] command on the PE device to check PW information about the remote end of the Martini VLL.

  • Run the display mpls static-l2vc [ interface interface-type interface-number ] command to check information about an SVC VLL.

  • Run the display l2vpn ccc-interface vc-type static-vc [ down | up ] command to view information about VC interfaces in the Up/Down state on the SVC VLL.

  • Run the display bgp l2vpn { all | group [ group-name ] | peer [ [ peer-ip-address ] verbose ] | route-distinguisher route-distinguisher [ ce-id ce-id [ label-offset label-offset ] ] } command to check BGP routing information of a Kompella VLL.

  • Run the display mpls l2vpn connection [ vpn-name [ remote-ce ce-id | down | up | verbose ] | summary | interface interface-type interface-number ] command to check information about the Kompella VLL.

  • Run the display mpls l2vpn [ l2vpn-name [ local-ce | remote-ce ] ] command to check L2VPN information about the Kompella VLL on the PE device.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39331

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next