No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting and Viewing Statistics on Tunnel Interfaces

Collecting and Viewing Statistics on Tunnel Interfaces


To check network status or locate network faults, you can enable traffic statistics collection on tunnel interfaces and collect traffic statistics on tunnel interfaces.


  1. Run the system-view command to enter the system view.
  2. Run the interface tunnel interface-number command to create a tunnel interface and enter the tunnel interface view.
  3. Run the statistic enable { both | inbound | outbound } command to enable traffic statistics collection on a tunnel interface.

    By default, traffic statistics collection is disabled on a tunnel interface.

  4. Run the display interface tunnel command to display traffic statistics on the tunnel interface.

Follow-up Procedure

Run the reset counters interface tunnel [ interface-number ] command in the user view to reset statistics on a tunnel interface to differentiate between the original statistics.

After you reset the statistics on a specified tunnel interface, statistics information about the number of sent and received packets and the packet transmission rate are cleared. Exercise caution when you run this command.

Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39095

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next