No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the PW Redundancy Configuration

Verifying the PW Redundancy Configuration

Prerequisites

The configurations of PW redundancy in a scenario where CEs are asymmetrically connected to PEs are complete.

Procedure

  • Run the display mpls l2vc [ vc-id | interface interface-type interface-number | remote-info [ vc-id ] | state { down | up } ] command to check L2VC information.
  • Run the display mpls l2vc track admin-vc interface loopback interface-number [ upe ] command to check service PWs or switching PWs associated with the mPW.
  • Run the display mpls switch-l2vc [ ip-address vc-id encapsulation encapsulation-type | state { down | up } ] command to check switching PW information.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 38537

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next