No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Basic BGP/MPLS IP VPN Configuration Tasks

Summary of Basic BGP/MPLS IP VPN Configuration Tasks

Table 3-6  Basic BGP/MPLS IP VPN configuration tasks

Configuration Task

Sub-task

Configuration

Configure the MPLS VPN backbone network.

Confirm requirements of VPN users.

  1. Determine number of devices and interfaces based on the network scale, including:
    • Number of users
    • Number of VPNs for each user
    • Number of VPN instances for each VPN
  2. Routing protocol used on the backbone network
    NOTE:

    RIP-1 cannot be used on the backbone network.

Configure routing between backbone devices.

Configure an Interior Gateway Protocol (IGP) on the PE and P devices of the MPLS backbone network to achieve IP connectivity on the backbone network.

For detailed configuration, see S7700 and S9700 V200R013C00 Configuration Guide - IP Unicast Routing Configuration Guide.

Enable MPLS on backbone devices.

Enable MPLS and configure a Label Distribution Protocol (LDP) to set up public network tunnels. The LDP can be MPLS LDP or Resource Reservation Protocol-Traffic Engineering (RSVP-TE).
  • For detailed configuration, see the MPLS LDP Configuration in the S7700 and S9700 V200R013C00 Configuration Guide - MPLS.
  • For detailed configuration, see the Configuring a Dynamic MPLS TE Tunnel in "MPLS TE Configuration" in the S7700 and S9700 V200R013C00 Configuration Guide - MPLS.

You also need to configure VPN tunnel policies when VPN services need to be transmitted over TE tunnels or when multiple tunnels need to perform load balancing to fully use network resources. For detailed configuration, see Configuring Tunnel Policies.

Configure MP-IBGP between PE devices.

See Establishing MP-IBGP Peer Relationships Between PE Devices.

Connect MPLS VPN users.

Configure VPN instances on PE devices.

See Configuring a VPN Instance on a PE Device.

Bind VPN instances to interfaces.

See Binding a VPN Instance to an Interface.

Configure route exchange between PE and CE devices.

See Configuring Route Exchange Between PE and CE Devices.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 38979

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next