No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S7700 and S9700 V200R013C00

This document describes the configurations of VPN, including GRE, IPSec, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, VPLS, L2VPN Access to L3VPN.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PWE3 Carrying Enterprise Leased Line Services on a MAN

PWE3 Carrying Enterprise Leased Line Services on a MAN

Usage Scenario

Figure 6-14 shows a typical single-segment PWE3 networking. A carrier establishes a MAN to provide PWE3 services. A customer has two branches far from each other. If the customer use leased lines to connect the branches, it will result in high costs. The customer can request the carrier to establish a PWE3 connection between PE1 in branch A and PE2 in branch B.

PWE3 ensures stable Layer 2 communication between branches A and B, facilitates networking, and allows branches A and B to communicate with each other like on a LAN.

Figure 6-14  PWE3 carrying enterprise leased line services on a MAN

PWE3 Deployment

  1. IP addresses and IGPs are configured on the carrier MPLS backbone network so that PEs can communicate.
  2. MPLS is enabled on the carrier MPLS backbone network, and a TE tunnel is configured between PE1 and PE2. Usually, two TE tunnels are configured to provide tunnel protection.
  3. MPLS L2VPN is enabled on PE1 and PE2 and a remote MPLS LDP session is set up between them.
  4. PWE3 is configured on AC interfaces of PE1 and PE2 so that PE1 and PE2 can communicate over an MPLS L2VC.
Updated: 2019-04-08

Document ID: EDOC1100065751

Views: 39040

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next