No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Interface Management

S9300, S9300E, and S9300X V200R013C00

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Training Function on a 100GE Interface

Configuring the Training Function on a 100GE Interface

Context

With the increase of transmission rate or frequency, attenuation of signal's high-frequency components becomes increasingly severe. To guarantee transmission performance of signals, it is necessary to compensate for signals, and commonly used compensation technologies are pre-emphasis and balancing. The pre-emphasis technology increases high-frequency components of signals at the transmit end of transmission lines to compensate attenuation during the transmission. However, the pre-emphasis technology increases crosstalk while amplifying high-frequency components. To solve this problem, the balancing technology is developed. The balancing technology is used at the receive end of transmission lines to function like a filter for filtering high-frequency crosstalk.

After the training function is enabled on a 100GE interface, the transmit end exchanges frames with the receive end to automatically set the pre-emphasis and balancing parameters, improving processing efficiency of the two technologies. Note that the negotiated parameters for the training function are obtained based on the site environment. If the site environment changes, for example, from high-temperature environment to low-temperature environment, the parameters may be inaccurate. Therefore, bit errors may occur when the training function is enabled. The training function is optional in IEEE802.3 standards, and its implementation on different types of products from various vendors may differ.

When connecting two devices, enable or disable the training function on both ends simultaneously. By default, the training function is enabled on a 100GE interface. If the training function is disabled on the remote device or the remote device does not support the function, run the training disable or undo training enable command to disable the function.

NOTE:

Only the LE1D2C04HX2E and LE1D2H02QX2E cards of the X2E series, LE3D2C04HX2L card of the X2L series, and LE1D2C04HX2S and LE1D2H02QX2S cards of the X2S series support this command.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run training disable or undo training enable

    The training function is disabled on the interface.

    By default, the training function is enabled on an interface.

    Precautions

    • The training disable and undo training enable commands can be configured on a 100GE interface only when the interface connects to a 40GE cable.

    • After a 40GE cable is installed on a 100GE interface without the training disable configuration, the training enable configuration is automatically generated on the interface.

    • If no cable is installed on an interface, only the training enable and undo training disable commands can be configured on the interface.

    • If the display this include-default command is run on an interface to view the training configuration after a cable is installed on the interface, the default training enable configuration is always displayed in the command output and does not change with the training configuration change.
    • The training configuration on an interface takes effect only after a cable is installed on the interface. If the cable is replaced with an optical module, the training disable and training enable configurations will be automatically deleted from the interface.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065861

Views: 4944

Downloads: 8

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next