No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Interval for Sending Traps

Setting the Interval for Sending Traps

Context

If the BFD module is enabled with the SNMP alarm function, the NMS will receive BFD Up or Down messages. If the BFD session flaps, the NMS receives a large number of traps. In this case, BFD traps need to be suppressed. Run the snmp-agent bfd trap-interval command to set the interval at which traps are sent to prevent overflow of traps.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is enabled globally and the BFD view is displayed.

  3. Run snmp-agent bfd trap-interval interval

    The interval at which traps are sent is set.

    By default, the interval at which traps are sent is 120s.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 18679

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next