No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Device Priority in a VRRP Group

Setting the Device Priority in a VRRP Group

Context

Devices with higher priorities in a VRRP group are more likely to become the master. You can specify the master to forward traffic by setting device priorities.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run vrrp vrid virtual-router-id priority priority-value

    The device priority in a VRRP group is set.

    By default, the device priority is 100. A larger value indicates a higher priority of VRRP Advertisement packets.

    • Priority 0 is reserved in the system. Priority 255 is reserved for the IP address owner. The configurable priority ranges from 1 to 254.

    • The priority of an IP address owner is fixed at 255 and cannot be manually changed. You can run the vrrp vrid virtual-router-id priority priority-value command to change the priority of an IP address owner, but the configured priority does not take effect. If a VRRP device is no longer an IP address owner, the configured priority is used.

    • In a VRRP group, if devices have the same priority and attempt to become the master simultaneously, the device where the interface with the largest IP address resides becomes the master. The device that first enters the Master state becomes the master, and other backups remain unchanged.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 18032

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next