No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the EFM Working Mode on an Interface

(Optional) Setting the EFM Working Mode on an Interface

Context

EFM supports two connection modes: active and passive. Table 8-10 describes capabilities for processing OAMPDUs supported by these modes.

Table 8-10  Capabilities for processing OAMPDUs in active and passive modes

Action

Active Mode

Passive Mode

Initiate a connection request by sending an Information OAMPDU during the discovery process

Supported

Not supported

Respond to a connection request during the discovery process

Supported

Supported

Send Information OAMPDUs

Supported

Supported

Send Event Notification OAMPDUs

Supported

Supported

Send Loopback Control OAMPDUs

Supported

Not supported

Respond to Loopback Control OAMPDUs

Supported (The remote EFM entity must work in active mode.)

Supported

EFM can be configured on Layer 2 and Layer 3 Ethernet interfaces. By default, an Ethernet interface works in Layer 2 mode. Before configuring EFM on a Layer 3 Ethernet interface, switch the Ethernet interface to Layer 3 mode.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface at one end of the link is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run efm mode { active | passive }

    The EFM working mode on the interface is configured.

    By default, EFM on an interface works in active mode.

    NOTE:
    • The EFM working mode can be set on an interface only after EFM is enabled globally and before EFM is enabled on the interface. The EFM working mode on an interface cannot be changed after EFM is enabled on the interface.

    • When using EFM to monitor a link, ensure that either of the interfaces at both ends of the link operates in active mode.
      • If both ends of a link are configured to work in active EFM mode, link detection can be implemented.

      • If both ends of a link are configured to work in passive mode, link detection cannot be implemented.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 15871

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next