No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Basic Concepts of Monitor Link

Basic Concepts of Monitor Link

Monitor Link monitors an uplink interface's state and changes the state of the associated downlink interface accordingly. The uplink and downlink interfaces form a Monitor Link group (see Figure 6-9).

Figure 6-9  Example of Monitor Link implementation

Monitor Link Group

A Monitor Link group consists of uplink and downlink interfaces. A member of a Monitor Link group can be a single interface, static link aggregation group, manual link aggregation group, or Smart Link group. A Smart Link group can only function as the uplink interface. The downlink interface state changes with the uplink interface state. In Figure 6-9, Interface1 and Interface2 form a Monitor Link group, and Interface3 and Interface4 form a Monitor Link group.

Uplink Interface

An uplink interface is monitored by the downlink interfaces in a Monitor Link group. If the uplink interface fails, all the downlink interfaces in the Monitor Link group are forcibly shut down. As shown in Figure 6-9, Interface1 and Interface3 are uplink interfaces. When a Smart Link group is used as the uplink interface, the uplink interface is considered faulty only when both the master and slave interfaces of the Smart Link group are in Inactive or Down state. As shown in Figure 6-10, the Smart Link group is used as the uplink interface of the Monitor Link group.

Figure 6-10  Combination of Smart Link and Monitor Link

Downlink Interface

Downlink interfaces monitor the uplink interface in the same Monitor Link group. A failure of a downlink interface does not affect the uplink interface or the other downlink interfaces. In Figure 6-9, Interface2 and Interface4 are downlink interfaces.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 22677

Downloads: 13

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next