No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling the Switch to Rapidly Sending Gratuitous ARP Packets During an Active/Standby Switchover of a VRRP Group Triggered by the Associated Peer BFD Session

(Optional) Enabling the Switch to Rapidly Sending Gratuitous ARP Packets During an Active/Standby Switchover of a VRRP Group Triggered by the Associated Peer BFD Session

Context

On a network where association between a VRRP group and a peer BFD session is configured, when the peer BFD session on the backup detects a fault on the active link, the peer BFD session instructs the VRRP group to perform an active/standby switchover. The new master sends gratuitous ARP packets to its downstream Layer 2 device through the software protocol stack so that traffic is switched to the new master.

To speed up traffic switching, run this command to enable the switch to rapidly send gratuitous ARP packets during an active/standby switchover of a VRRP group triggered by its associated peer BFD session. When the peer BFD session on the backup detects the fault on the active link, the hardware rapidly sends gratuitous ARP packets to its downstream Layer 2 device so that traffic is switched to the new master.

NOTE:

The S9306 and S9312 support this function only when the MPU is equipped with the LE0MFSUA.

The S9306E and S9312E support this function only when the MPU is LH2D2SRUDC00 or LE2D2SRUDC01.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number.subinterface-number

    The sub-interface view is displayed.

  3. Run vrrp track bfd gratuitous-arp send enable

    The switch is enabled to rapidly send gratuitous ARP packets during an active/standby switchover of a VRRP group triggered by its associated peer BFD session.

    By default, the switch is not enabled to rapidly send gratuitous ARP packets during an active/standby switchover of a VRRP group triggered by its associated peer BFD session.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 18821

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next