No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Local MAC Swap Loopback

Configuring Local MAC Swap Loopback

Context

Before performing a local MAC swap loopback test, configure the source MAC address, destination MAC address, and VLAN ID of test packets on the Switch. Only the packets with the specified source MAC address, destination MAC address, and VLAN ID are looped back.

When a local MAC swap test is performed on an interface, services on the interface are interrupted, but services on other interfaces are not affected. However, if a large number of test packets are sent, test packets occupy bandwidth of other services on the interface that sends test packets back to the tester.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run loopback local swap-mac source-mac source-mac-address dest-mac dest-mac-address vlan vlan-id [ inner-vlan inner-vlan-id ] interface interface-type interface-number [ timeout { time-value | none } ]

    NOTE:

    SA cards support loopback of only single-tagged Ethernet frames.

    If the single VLAN tag option is configured on any card except LE0MG24CA or LE0MG24SA, the test packets cannot be double-tagged.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 18252

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next