No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a VRRP6 Preemption Mode

(Optional) Configuring a VRRP6 Preemption Mode

Context

If the BFD session status monitored by a VRRP6 group flaps frequently or the backups cannot receive VRRP6 Advertisement packets within a specified period, an active/standby switchover is frequently performed. This causes network flapping. The VRRP6 preemption mode and preemption delay can be configured on the switch to enhance the stability of the master and backup.

NOTE:

You are advised to set the preemption delay of the backup in a VRRP6 group to 0, configure the master in preemption mode, and set the preemption delay. On an unstable network, these settings allow a period of time for status synchronization between the uplink and downlink. If the preceding settings are not used, two masters coexist and user devices may learn the incorrect address of the master.

Procedure

  • Configure non-preemption for the VRRP6 group on the switch.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run vrrp6 vrid virtual-router-id preempt-mode disable

      The non-preemption mode is configured on the switch.

      By default, the device uses the immediate preemption mode.

      In non-preemption mode, the master that works properly retains the Master state. This state cannot be preempted even if other switches have a higher priority than that of the master.

      You can use the undo vrrp6 vrid virtual-router-id preempt-mode command to restore the default preemption mode.

  • Configure a preemption mode on the switch and set the preemption delay.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run vrrp6 vrid virtual-router-id preempt-mode timer delay delay-value

      The preemption delay is set.

      By default, the preemption delay is 0, indicating immediate preemption. In immediate preemption mode, a backup immediately assumes the master role when detecting that its priority is higher than the master's priority.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 15618

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next