No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Connectivity Check

Configuring Connectivity Check


Because different customers require different QoS, CFM provides different CCM intervals to meet the requirements. If a MEP receives no CCMs from an RMEP within three consecutive intervals for sending CCMs, a connectivity fault between the MEP and RMEP occurs.


  1. Run system-view

    The system view is displayed.

  2. Run cfm md md-name

    The MD view is displayed.

  3. Run ma ma-name

    The MA view is displayed.

  4. Run ccm-interval interval

    The interval for a MEP to send or detect CCMs in an MA is set.

    By default, a MEP sends or detects CCMs every 1 second.

    All the MEPs in an MA must send or detect CCMs at the same interval.

    The interval at which CCMs are sent or received cannot be modified on the device in an MA if one of the following operations is performed:

    • The device is enabled to send CCMs using the mep ccm-send enable command.

    • The device is enabled to receive CCMs using the remote-mep ccm-receive enable command.

    The undo mep ccm-send enable or undo mep ccm-receive enable command must be run before the interval is reconfigured.

  5. Run mep mep-id mep-id interface interface-type interface-number { outward | inward }

    The MEP is created.

  6. Run mep ccm-send [ mep-id mep-id ] enable

    The MEP is enabled to send CCMs.

    By default, a MEP is disabled from sending CCMs.

    If mep-id mep-id is not specified, all the MEPs in the MA are enabled to send CCMs.

  7. Run remote-mep ccm-receive [ mep-id mep-id ] enable

    The MEP is enabled to receive CCMs from the RMEP in the same MA.

    By default, a MEP is disabled from receiving CCMs from an RMEP.

    When a MEP is enabled to receive CCMs from an RMEP and a connectivity fault is detected between the local MEP and the RMEP using CC, the MEP generates an alarm.

    If mep-id mep-id is not specified, the MEP is enabled to receive CCMs from all the RMEPs in the same MA.

Follow-up Procedure

  • To enable continuity check in multiple MAs, repeat step 3 to step 6.

  • To enable continuity check in multiple MDs, repeat step 2 to step 6.

Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 18646

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next