No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between VRRP and NQA to Monitor the Uplink Status

Configuring Association Between VRRP and NQA to Monitor the Uplink Status

Context

VRRP cannot detect faults on the uplink of a VRRP group, which may cause service interruption. You can associate a VRRP group with an NQA test instance on the master so that the NQA test instance monitors the uplink status of the master. When the NQA test instance detects a fault on the uplink, it notifies the VRRP group that the priority of the master needs to be decreased. Then an active/standby switchover is triggered immediately. This reduces the impact of the uplink fault on service forwarding.

When the fault is rectified, the original master restores its priority and becomes the master again to forward traffic.

NQA technology collects statistics on the delay, jitter, and packet loss rate. You can configure the percentage of failed NQA test instances and NQA association to trigger an active/standby switchover when the uplink is unstable.

NOTE:
  • A VRRP group can be associated only with an NQA ICMP test instance.

  • The master and backup in the VRRP group must work in preemption mode. It is recommended that the preemption delay be 0 on the backup and non-zero on the master.

Procedure

  1. Create an NQA ICMP test instance. For details, see Configuring an ICMP Test Instance in "NQA Configuration" in the S9300, S9300E, and S9300X V200R013C00 Configuration Guide - Network Management and Monitoring.
  2. Run system-view

    The system view is displayed.

  3. Run interface interface-type interface-number

    The view of the interface on the master where a VRRP group is configured is displayed.

  4. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  5. Run vrrp vrid virtual-router-id track nqa admin-name test-name [ reduced value-reduced ]

    Association between VRRP and NQA is configured.

    By default, when the associated NQA test instance becomes failed, the priority of the device decreases by 10.

    NOTE:

    When setting the value by which the priority decreases, ensure that the priority of the backup is higher than the priority of the master to trigger an active/standby switchover.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 18810

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next