No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BFD for VRRP

BFD for VRRP

If the Virtual Router Redundancy Protocol (VRRP) master fails, the VRRP backup with the highest priority takes over traffic within a short time to shorten service interruption.

VRRP determines whether to perform preemption based on the timeout interval of the backup. The switching takes longer than 1 second. BFD can be used to quickly detect the master status and shorten traffic interruption. BFD detects real IP addresses of the master and backup devices during communication. If communication is irregular, the backup device considers the master device to be Down and takes over. A VRRP group implements an active/standby VRRP switchover quickly by tracking the BFD session status. The switchover time is within 50 milliseconds.

Application

Figure 2-13  BFD for VRRP

In Figure 2-13, SwitchA and SwitchB establish a VRRP group. SwitchA functions as the master and SwitchB functions as the backup. User traffic is transmitted through SwitchA. SwitchA and SwitchB establish a BFD session and the VRRP group tracks the BFD session status. When the BFD session status changes, the priority of the VRRP group is changed, triggering an active/standby switchover.

The fast active/standby VRRP switchover process is as follows:
  1. When a BFD session detects a link fault between SwitchA and SwitchC, BFD reports a Down event to VRRP.
  2. The priority of SwitchB in the VRRP group increases above the priority of SwitchA.
  3. SwitchB becomes the master switch immediately, and subsequent user traffic is forwarded through SwitchB.
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065868

Views: 15726

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next