No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - Device Management

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, OPS, energy-saving management, information center, fault management, NTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Performing a Master/Standby Switchover

Performing a Master/Standby Switchover

Context

If you want another switch in the stack to be the master switch, perform a master/standby switchover to change a standby switch to the new master switch.

After the master/standby switchover is complete, the role of each member switch in the stack changes as shown in Figure 3-34.

Figure 3-34  Role changes of member switches in the stack
  • The original standby switch becomes the master switch.
  • The new master switch assigns a specified switch as the standby switch.
  • The original master switch restarts and rejoins the stack and becomes a slave switch.

Procedure

  1. (Optional) Run the display switchover state command to check whether the stack meets requirements for a switchover.
  2. Run the system-view command to enter the system view.
  3. Run the slave switchover enable command to enable master/standby switchover.

    By default, master/standby switchover is enabled.

  4. Run the slave switchover command to perform a master/standby switchover.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100066159

Views: 25331

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next