No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - Device Management

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, OPS, energy-saving management, information center, fault management, NTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Outputting Traps to the Console

Example for Outputting Traps to the Console

Networking Requirements

As shown in Figure 9-10, the PC connects to SwitchA through a console interface. It is required that debugging messages of the ARP module be displayed on the PC.

Figure 9-10  Networking diagram for outputting debugging messages to the console

Configuration Roadmap

The configuration roadmap is as follows:

  1. Enable the information center.

  2. Configure a channel and a rule for outputting debugging messages to the console so that the console can receive debugging messages generated by SwitchA.

  3. Enable terminal display so that users can use the terminal to view debugging messages generated by SwitchA.

Procedure

  1. Enable the information center.

    <HUAWEI> system-view
    [HUAWEI] sysname SwitchA
    [SwitchA] info-center enable
    

  2. Configure a channel and a rule for outputting debugging messages to the console.

    # Configure a channel for outputting debugging messages to the console.

    [SwitchA] info-center console channel console
    

    # Configure a rule for outputting debugging messages to the console.

    [SwitchA] info-center source arp channel console debug level debugging state on
    [SwitchA] quit

  3. Enable terminal display.

    <SwitchA> terminal monitor
    <SwitchA> terminal debugging
    

  4. Debug the ARP module.

    <SwitchA> debugging arp packet

  5. Verify the configuration.

    # View debugging message output.

    <SwitchA> display channel 0
    channel number:0, channel name:console
    MODU_ID  NAME     ENABLE LOG_LEVEL     ENABLE TRAP_LEVEL    ENABLE DEBUG_LEVEL
    ffff0000 default  Y      warning       Y      debugging     Y      debugging
    416e0000 ARP      Y      warning       Y      debugging     Y      debugging
    

Configuration Files

SwitchA configuration file

#
sysname SwitchA
#
info-center source ARP channel 0
#
return
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100066159

Views: 25459

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next