No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - Device Management

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, OPS, energy-saving management, information center, fault management, NTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring EEE

Configuring EEE


A device provides power for each interface. Even though an interface is idle, it consumes the same power as working interfaces. This wastes power. After the Energy Efficient Ethernet (EEE) function is configured on an electrical interface, the system reduces the power on the interface when the interface is idle and restores the power when the interface starts to transmit data. This reduces power consumption in the system.


If an electronic interface works at 10 Mbit/s after auto-negotiation, the EEE function does not take effect.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run energy-efficient-ethernet enable

    EEE function is enabled on the electrical interface.

    By default, the EEE function is disabled on an electrical interface.


    The EEE function takes effect only when it is configured on both ends of a link.

Verifying the Configuration

  • Run the display this command in the interface view to check whether the EEE function is enabled.

Updated: 2019-04-20

Document ID: EDOC1100066159

Views: 26660

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next