No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - Device Management

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, OPS, energy-saving management, information center, fault management, NTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Displaying Stack IDs Through Service Port Indicators

Displaying Stack IDs Through Service Port Indicators

After a stack is set up, use either of the following methods to display stack IDs through service port indicators:
  • Press the mode switching button to change the mode status indicator to the stack mode without logging in to the stack. You can then determine the stack IDs of the master switch and other stack members by viewing the status of the mode status indicator and service port indicators.

    The Table 3-8 describes how service port indicators determine stack IDs of stack members:
    Table 3-8  Service port indicators in STACK mode
    Color Status and Meaning

    Off

    This indicator does not indicate the stack ID of a stack member.

    Green

    • If the indicator of a service port is blinking green, the switch where this service port is located is the master switch, and the number of this service port is the stack ID of this switch.
    • If the first to nine service ports indicators of the switch are blinking green, this switch is the master switch, and its stack ID is 0.
    • If the indicator of a service port is steady green, the switch where this service port is located is not the master switch, and the number of this service port is the stack ID of this switch.
    • If the first to nine service ports indicators of the switch are steady green, this switch is not the master switch, and its stack ID is 0.
  • Log in to the stack and run the stack led enable [ duration duration-value ] command to enable service port indicators to display stack IDs of stack members.
    NOTE:

    This command can be executed only when the mode switching button is not pressed to set the mode status indicator to the STACK mode.

    This command configuration becomes invalid after port indicators show stack IDs of stack members for the specified time.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100066159

Views: 25769

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next